How To Replace Sliding Patio Door Screen

Replacing a sliding patio door screen is a relatively simple task that can be completed in a matter of minutes. By following these step-by-step instructions, you can easily replace your old screen with a new one and enjoy a fresh breeze without any pesky bugs.

Materials You'll Need:

New sliding patio door screen
Measuring tape
Scissors
Utility knife
Screwdriver
Hammer
Nails (optional)

Step-by-Step Instructions:

Measure the opening: Use a measuring tape to determine the width and height of the opening where the screen will be installed.
Cut the screen: Using scissors, cut a piece of screen material to the measured width and height, allowing for about an inch of overlap on all sides.
Remove the old screen: Locate the screws that hold the old screen in place and remove them using a screwdriver. Carefully lift the old screen out of the frame.
Insert the new screen: Place the new screen over the frame and align it properly. Ensure that there is an even amount of overlap on all sides.
Secure the screen: Using a hammer and nails, secure the screen to the frame by driving nails through the pre-drilled holes in the frame. Alternatively, you can use a screwdriver to tighten the screws if they are present.
Trim the excess: Use a utility knife to trim any excess screen material around the edges of the frame.
Enjoy the fresh air: Slide the screen back into its place and enjoy the fresh breeze without bugs.