How To Install A Screen In Patio Door

How to Install a Screen in a Patio Door

Installing a screen in a patio door is a great way to enjoy the fresh air and sunshine while keeping out bugs and debris. It is a relatively simple project that can be completed in a few hours. Here is a step-by-step guide on how to do it:

Materials You'll Need:

Screen material
Spline
Spline roller
Screwdriver
Scissors
Utility knife
Measuring tape

Instructions:

1. Measure the Patio Door Opening:

Measure the width and height of the patio door opening to determine the size of the screen you need.

2. Cut the Screen Material:

Cut the screen material to the size of the patio door opening, adding an extra inch on each side for overlap.

3. Install the Spline:

Use the screwdriver to insert the spline into the groove on the inside edges of the patio door frame. Start from one corner and work your way around the frame, pressing the spline into the groove as you go.

4. Cut the Spline:

Once the spline is fully inserted, cut off the excess with the utility knife.

5. Attach the Screen Material:

Place the screen material over the spline and use the spline roller to press it into the groove. Start from the center and work your way out to the edges.

6. Trim the Excess Screen:

Use the utility knife to trim the excess screen around the edges of the patio door frame.

7. Secure the Screen:

Use screws to secure the screen to the patio door frame, spacing them about 12 inches apart.

Tips:

Use a fine-mesh screen material to keep out even the smallest bugs.

If you are not sure how to measure the patio door opening, consult with a professional.

Be careful not to over-tighten the screws, as this can damage the screen.

Inspect the screen regularly and make repairs as needed.

By following these steps, you can easily install a screen in your patio door and enjoy the benefits of fresh air and sunshine without the hassle of bugs and debris.